Volume 38, Issue 3 (Journal of Advanced Materials-Fall 2019)                   jame 2019, 38(3): 57-71 | Back to browse issues page


XML Persian Abstract Print


Department of Materials Engineering, Malek Ashtar University of Technology. , ehsan_sharifi_2000@yahoo.com
Abstract:   (2274 Views)
Finite element (FE) simulations in conjunction with experimental analysis were carried out to characterize the deformation behavior of an AISI 321 austenitic stainless steel (ASS) during cold pilgering process. The effect of process parameters including feed rate (4 and 8 mm) and turn angle (15, 30 and 60°) on damage build-up were also evaluated. The Johnson-cook model was used to simulate the flow behavior of material. By considering compressive stresses, a new revised Latham-Cockcraft damage was calculated and used to determine the optimum process parameters. It was found that the radial and hoop strains in all friction conditions were compressive, while the axial strains were observed to be tensile. The amount of strain (whether it is compressive or tensile strain) was also higher on the outside of the tube compared to its inside. By considering fatigue cycles of a tube element during the process, the feed rate of 8mm, turn angle of 60° and the lowest coefficient of friction were determined as optimum parameters.
Full-Text [PDF 821 kb]   (402 Downloads)    
Type of Study: Research | Subject: Forming and mechanical properties
Received: 2019/05/1 | Accepted: 2019/08/28 | Published: 2019/12/1