A.A. Gharehaghaji, Using Artificial Neural Network Algorithm to Predict Tensile Properties of Cotton-Covered Nylon Core Yarns [Volume 24, Issue 2, 2006, Pages 241-251]
A. A. Gharehaghaji and M. Rafimanzelat, Effects of Changes in Front Drafting Rollers Geometry on the Properties of Ring Spun Yarns [Volume 24, Issue 1, 2005, Pages 367-380]
A.B. Kabiri Samani, Experimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow [Volume 24, Issue 2, 2006, Pages 69-86]
A. Ebrahimi, Near-Minimum Time Optimal Control of Flexible Spacecraft during Slewing Maneuver [Volume 24, Issue 2, 2006, Pages 123-135]
A. Eslami, Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data [Volume 24, Issue 1, 2005, Pages 77-95]
A. Keshavarzi and M. J. Kazemzadeh Parsee, Numerical and Experimental Analysis of the Effect of Flow Discharge Ratio on Flow Separation at 45 Degree Open End Water Intake [Volume 24, Issue 1, 2005, Pages 213-232]
A. M. Momeni, Behavior of Castellated I Beams Encased in Concrete [Volume 24, Issue 1, 2005, Pages 121-134]
A. R. Azimian, Thermo-economic Analysis of Power Cycles [Volume 24, Issue 1, 2005, Pages 413-424]
A. R. Pishevar and A. R. Shateri, A New Implicit Dissipation Term for Solving 3D Euler Equations on Unstructured Grids by GMRES+LU-SGS Scheme [Volume 24, Issue 1, 2005, Pages 233-249]
B
B. Saghafian, The Effect of Station Density and Regional Division on Spatial Distribution of Daily Rainfall [Volume 24, Issue 1, 2005, Pages 59-75]
D
D. Mostofinejad and M. Reisi, Effect of Limestone Powder on Compressive Strength of Concrete Containing Silica Fume and Optimization of Mix Design Using Response Surface Method [Volume 24, Issue 1, 2005, Pages 401-411]
F
F. Farhat-Nia and M. Salimi, Application of Modified Slab Method in Asymmetrical Plate Rolling [Volume 24, Issue 2, 2006, Pages 137-158]
H
H. M. M. Sadeghi and H. Bayat, investigation of Parameters Affecting Abrasion Resistance of R.C.C. [Volume 24, Issue 1, 2005, Pages 155-176]
H. Saeedi, Performance Improvement of Radar Target Detection by Wavelet-based Denoising Methods [Volume 24, Issue 1, 2005, Pages 17-29]
H. Seifi, A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects [Volume 24, Issue 1, 2005, Pages 1-15]
H. Taheri Shahraeeni and J. Ghayoomian, The Effect of Station Density and Regional Division on Spatial Distribution of Daily Rainfall [Volume 24, Issue 1, 2005, Pages 59-75]
J. Emadi, Analysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method [Volume 24, Issue 1, 2005, Pages 391-399]
J. Safarian-Dastjerdi and A. Saidi, Effects of Coating Golegohar-Chadormalu Pellet on Its Behaviour in Direct Reduction Process [Volume 24, Issue 1, 2005, Pages 425-433]
K
K. Alavie and M. M. Jafariean, Stability Analysis for Wake Flow Behind a Flat Plate [Volume 24, Issue 1, 2005, Pages 271-282]
K. Badv, Evaluation of Optimum Landfill Design by Contaminant Transport Analysis [Volume 24, Issue 1, 2005, Pages 135-153]
K. Eshghi and H. Djavanshir, An Efficient Algorithm for Reducing the Duality Gap in a Special Class of the Knapsack Problem [Volume 24, Issue 1, 2005, Pages 47-57]
K. Rezaie and N. Seid Foroush Lahiji, A New Heuristic Algorithm for Time-cost Trade-off Problem Taking into Account Monetary Value [Volume 24, Issue 1, 2005, Pages 31-46]
M
M.A. Niazi, Thermo-Elastic-Plastic Analysis of Plate Forming Process by Flame Bending Method [Volume 24, Issue 2, 2006, Pages 159-170]
M.A.Rowshanzamir and A. Jafari, Investigation of Shear Strength Anisotropy of c- &phi Soils [Volume 24, Issue 2, 2006, Pages 87-103]
M. Asgaree and M. S. Seif M., Hydrodynamic Resistance Reduction in Catamaran Assisted Hydrofoils [Volume 24, Issue 1, 2005, Pages 251-269]
M. Borgheie and M.H Saeidi, Experimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow [Volume 24, Issue 2, 2006, Pages 69-86]
M. Ebrahimi and A. Ghaderi, Evaluation of LPF and PCLPF and Development of a Novel Method to Solve DC Offset Problem in Vector Control of Induction Motors [Volume 24, Issue 2, 2006, Pages 1-14]
M. Farmad and M. Gaznavi, A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects [Volume 24, Issue 1, 2005, Pages 1-15]
M. Ghorbani and A.M. Saedi, Ternary Ni-Fe-Co Alloys Nanowire Electrodeposition [Volume 24, Issue 2, 2006, Pages 215-226]
M. Hosseinalipour, A Numerical Study of Dynamic Detonability Characteristics of Two-phase Unconfined Fuel-Air Clouds [Volume 24, Issue 2, 2006, Pages 105-122]
M. Kahrom, Stability Analysis for Wake Flow Behind a Flat Plate [Volume 24, Issue 1, 2005, Pages 271-282]
M. Kamalian and A. Sohrabi Bidar, Transient Site Response Analysis of Nonhomogeneous Two-dimensional Topographic Features Using BEM [Volume 24, Issue 2, 2006, Pages 51-68]
M. Karimpoor Fard and N. Shariatmadari, Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data [Volume 24, Issue 1, 2005, Pages 77-95]
M. k. Beirami and M. Ilaghi Hoseiny, Forced Hydraulic Jump by One and Two Continuous Sills in a Horizontal Stilling Basin. [Volume 24, Issue 1, 2005, Pages 97-119]
M. Maarefat, Thermo-Elastic-Plastic Analysis of Plate Forming Process by Flame Bending Method [Volume 24, Issue 2, 2006, Pages 159-170]
M. M. Doustdar and K. Mazaheri, A Numerical Study of Dynamic Detonability Characteristics of Two-phase Unconfined Fuel-Air Clouds [Volume 24, Issue 2, 2006, Pages 105-122]
M. Modarres-Hashemi and S. Sadri, Performance Improvement of Radar Target Detection by Wavelet-based Denoising Methods [Volume 24, Issue 1, 2005, Pages 17-29]
M. Palhang, Using Artificial Neural Network Algorithm to Predict Tensile Properties of Cotton-Covered Nylon Core Yarns [Volume 24, Issue 2, 2006, Pages 241-251]
M. Parsa, A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects [Volume 24, Issue 1, 2005, Pages 1-15]
M. R. Heidari, Experimental Investigations of Supersonic Flow around a Long Axisymmetric Body [Volume 24, Issue 2, 2006, Pages 171-191]
M.R. Maheri and A Rangbaran, Effects of Support Conditions on Dynamic Behaviour and Seismic Response of Ghadir Bridge [Volume 24, Issue 1, 2005, Pages 177-196]
M. R. Omidkhah, A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects [Volume 24, Issue 1, 2005, Pages 1-15]
M. R. Soltani, Experimental Investigations of Supersonic Flow around a Long Axisymmetric Body [Volume 24, Issue 2, 2006, Pages 171-191]
M. Salimi and S. Asghari, Investigations on Cold Rolling of Strip in Attendance of Hydrodynamic Lubrication [Volume 24, Issue 1, 2005, Pages 283-297]
M. Shamanian and A. Saidi, Microstructural Effect on the Weldability of 25Cr-35Ni Cast Steel [Volume 24, Issue 1, 2005, Pages 327-336]
M. Taeibi-Rahni, Experimental Investigations of Supersonic Flow around a Long Axisymmetric Body [Volume 24, Issue 2, 2006, Pages 171-191]
M. Taghavi Ghadikolaee and S. H. Amirshahi, A Comparison between CIECAM97s and its Revised Colour Appearance Models for Apearance Attributes of Fabrics [Volume 24, Issue 2, 2006, Pages 227-239]
M. Vaziri, Temperature Distribution of a Non gray Gas between Two Parallel Planes Using Exponential Wide Band Model [Volume 24, Issue 1, 2005, Pages 299-314]
M. Ziyaeifar and M. Ghafory-Ashtiany, Mass Participation Factor in Defining Non-classical Range of Behavior for Mass Isolated Systems [Volume 24, Issue 2, 2006, Pages 29-49]
N
Nouri and A. M. Lavasani, Heat Transfer from a Tube Bank in Cross Flow in a Duct [Volume 24, Issue 1, 2005, Pages 315-325]
R
Rabbani, A New Heuristic Algorithm for Time-cost Trade-off Problem Taking into Account Monetary Value [Volume 24, Issue 1, 2005, Pages 31-46]
R.B.Kazemzadeh, Economic Design of R2R Controller using EWMA Procedure [Volume 24, Issue 2, 2006, Pages 15-28]
R. Hosseini, Temperature Distribution of a Non gray Gas between Two Parallel Planes Using Exponential Wide Band Model [Volume 24, Issue 1, 2005, Pages 299-314]
R.Noorossana and M. Karbasian, Economic Design of R2R Controller using EWMA Procedure [Volume 24, Issue 2, 2006, Pages 15-28]
S. A.A. Mousavian, Near-Minimum Time Optimal Control of Flexible Spacecraft during Slewing Maneuver [Volume 24, Issue 2, 2006, Pages 123-135]
Seyyed Jalal Hemmati, Thermo-Elastic-Plastic Analysis of Plate Forming Process by Flame Bending Method [Volume 24, Issue 2, 2006, Pages 159-170]
S. H. Hosseini, A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects [Volume 24, Issue 1, 2005, Pages 1-15]
Sh. Tavousi, Mass Participation Factor in Defining Non-classical Range of Behavior for Mass Isolated Systems [Volume 24, Issue 2, 2006, Pages 29-49]
S. M. Mortazavi and M. Sedighipoor, Hot Mercerizing of Cotton/Polyester Blend Fabric Effect of Alkali Treatment Temperature on Ttensile Properties , Weight Loss and Shrinkage of Fabric [Volume 24, Issue 1, 2005, Pages 355-365]
S. Monajem, Square Joints in Railway Track Waves [Volume 24, Issue 1, 2005, Pages 197-211]
S. Rahimi Bandarabadi, The Effect of Station Density and Regional Division on Spatial Distribution of Daily Rainfall [Volume 24, Issue 1, 2005, Pages 59-75]
S. Roushanbin, Effects of Support Conditions on Dynamic Behaviour and Seismic Response of Ghadir Bridge [Volume 24, Issue 1, 2005, Pages 177-196]
