Volume 40, Issue 1 (Journal of Advanced Materials-Spring 2021)                   jame 2021, 40(1): 45-63 | Back to browse issues page


XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Moradi R, Roshanaee M, Mostaan H, Nematzadeh F, Safari M. MICROSTRUCTURAL STUDIES ON LASER WELDING OF INCONEL 718 TO 2304 DUPLEX STAINLESS STEEL WITH A FOCUS ON OPTIMAZING PROCESS PARAMETERS AND ACHIEVING THE MAXIMUM FRACTURE STRENGTH. jame. 2021; 40 (1) :45-63
URL: http://jame.iut.ac.ir/article-1-1084-en.html
Department of Materials and Metallurgical Engineering, Faculty of Engineering, Arak University, Arak, Iran , h-mostaan@araku.ac.ir
Abstract:   (630 Views)
In this research, microstructure and mechanical properties of laser welded joints between 2304 duplex stainless steel and Inconel 718 nickel-based super alloy were investigated. Microstructural evolution in the various areas of welded joints and also the effect of welding parameters on the mechanical properties of dissimilar joints were studied. Response surface methodology based on the central composite design was used in order to find the optimum welding parameters. Effective parameters of the welding process including laser power, travel speed and defocusing distance were set in the range of 1000 to 1900 W, 1 to 5 mm/s and -1 to 1 mm, respectively. Uniaxial tensile test was used to evaluate the fracture force of weld joints. The microstructural observations and phase evolutions were studied using optical microscope. It was found that the fracture force of the weld joints firstly increased by travel speed and defocusing distance and then decreased by further increase. The maximum fracture force was obtained when laser power, travel speed and defocusing distance were 1900 W, 3 mm/s and 0 mm, respectively. The center line of weld metal was mainly consisted of equiaxed grains where, columnar grains were formed in the fusion line. The obtained results from the hardness measurement showed that the hardness of Inconel 718 was decreased due to dissolution of TiC and NbC particles. 
Full-Text [PDF 911 kb]   (163 Downloads)    
Type of Study: Applicable | Subject: Welding and joining
Received: 2020/05/28 | Accepted: 2021/04/6 | Published: 2021/05/31

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2021 CC BY-NC 4.0 | Journal of Advanced Materials in Engineering (Esteghlal)

Designed & Developed by : Yektaweb