Volume 28, Issue 1 (Jun 2009)                   jame 2009, 28(1): 1-12 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

B. Saberpour, A. K. Taheri, J. M. Akhgar. Effect of Equal Channel Angular Extrusion on Dynamic Strain Aging of an Al-Mg-Si-Cu Alloy. jame 2009; 28 (1) :1-12
URL: http://jame.iut.ac.ir/article-1-500-en.html
Department of Materials Science & Engineering, Sharif University of Techmnology , saberpoor@mehr.sharif.ir
Abstract:   (8027 Views)
An Al-Mg-Si-Cu alloy was subjected to tensile testing, both under solutionized and ECAE-ed conditions, using strain rates of 10-4 s-1 to 10-1 s-1 at temperatures of 25 ˚C to 325 ˚C to investigate the dynamic strain aging (DSA) phenomenon in the alloy. Negative strain rate sensitivity (m) and increasing ultimate tensile stress were observed in the DSA region with increasing temperature . Regarding the activation energy of the phenomenon, it was suggested that the process is controlled by the interaction of Mg atoms with mobile dislocations at lower temperatures of DSA occurrence while at higher temperatures, the aggregation of Mg atoms and precipitates of a second phase decreases the amount of Mg atoms in the solid solution, resulting in the inverse DSA effect. Moreover, it was shown that at temperatures greater than 250 ˚C, the ratio of post-uniform to uniform elongation increases with increasing temperature or with decreasing strain rate due to the solute drag of Mg atoms in the Al matrix. Processing the alloy by ECAE transferred the negative m values to lower temperatures and decreased the tendency to DSA at higher temperatures. Calculating the mentioned ratio for the ECAE-ed specimens revealed that the post-uniform elongation dominates the uniform elongation at all examined temperatures and strain rates. Also, it was found that for ECAE-ed specimens, the ratio is not so sensitive to variations of temperature and strain rate.
Full-Text [PDF 608 kb]   (1444 Downloads)    
Type of Study: Research | Subject: General
Received: 2015/02/9 | Accepted: 2015/05/5 | Published: 2015/05/5

Add your comments about this article : Your username or Email:

Send email to the article author

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 CC BY-NC 4.0 | Journal of Advanced Materials in Engineering (Esteghlal)

Designed & Developed by : Yektaweb