Volume 34, Issue 1 (Journal of Advanced Materials-Spring 2015)                   jame 2015, 34(1): 105-121 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Fazel M, Garsivaz jazi1 M, Bahramzadeh S, Bakhshi S, Ramazani M, Bahramian A. Influence of Gr and MoS2 Particles on High Temperature Tribological Properties of Ni-SiC Composite Coating. jame 2015; 34 (1) :105-121
URL: http://jame.iut.ac.ir/article-1-645-en.html
Abstract:   (7329 Views)

Ni–SiC composite coatings are successfully employed as a protective coating in the inner walls of engine cylinders. In this study, Ni-SiC, Ni-SiC-MoS2 and Ni-SiC-Gr composite coatings were prepared from a sulfamate bath. Both mechanical and ultrasonic stirring were used simultaneously during the process. Taking into account the working temperature of engine cylinders, the wear behavior of coatings was evaluated at 25 to 300 ºC and the high temperature tribological properties of the coatings were investigated. Based on the results obtained from the wear tests, all three coatings showed almost good friction coefficient values at 25 and 100 ºC, which were close to each other. By increasing the temperature to 200-300 °C, the friction coefficient and weight loss values strongly increased. However, addition of solid lubricants caused the values to decrease. The Ni-SiC-Gr coating at all temperatures showed a good and stable behavior.

Full-Text [PDF 1806 kb]   (2282 Downloads)    
Type of Study: Research | Subject: Surface engineering and coatings
Received: 2015/06/28 | Accepted: 2015/06/28 | Published: 2015/06/28

Add your comments about this article : Your username or Email:

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 CC BY-NC 4.0 | Journal of Advanced Materials in Engineering (Esteghlal)

Designed & Developed by : Yektaweb