Volume 36, Issue 3 (Journal of Advanced Materials-Fall 2017)                   jame 2017, 36(3): 1-10 | Back to browse issues page


XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Khoobroo M, Maleki A, Niroumand B. Improving the Surface Properties of Gray Cast Iron through In-Situ Alloying. jame. 2017; 36 (3) :1-10
URL: http://jame.iut.ac.ir/article-1-661-en.html
1. Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran. , mortezakhoobroo@yahoo.com
Abstract:   (4589 Views)

Conventionally, alloying elements are being added to the whole melt; however, in this research in-situ surface alloying of gray cast iron was employed to improve surface properties of the castings. Wires of pure copper with diameters of 0.4 and 0.8 mm were inserted and fixed at bottom of sand molds before melting. Chemical composition analysis revealed the presence of copper from surface to a depth of 1 cm. Microstructural investigations indicated that graphite type changed from A to D and E. Moreover, the content of graphite phase decreased while that of pearlite increased at the surface. Hardness was higher at surface of copper added samples. Wear resistant of the in-situ surface alloyed samples was better than the no-copper added ones.
 

Full-Text [PDF 621 kb]   (2954 Downloads)    
Type of Study: Research | Subject: Solidification and casting
Received: 2015/08/17 | Accepted: 2016/10/1 | Published: 2017/11/14

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2021 CC BY-NC 4.0 | Journal of Advanced Materials in Engineering (Esteghlal)

Designed & Developed by : Yektaweb