Journal of Advanced Materials in Engineering

Journal of Advanced Materials in Engineering

Synthesis and Characterization of Cobalt-Zinc Ferrite Nanoparticles for Magnetic Hyperthermia Applications

Document Type : Original Article

Authors
1 Department of Chemistry, Faculty of Sciences, Yazd University, Yazd, Iran
2 Department of Physics, Faculty of Sciences, Yazd University, Yazd, Iran
Abstract
Introduction and Objectives: Spinel ferrites are a class of magnetic materials with the general formula AB2O4. These ferrites have attracted the attention of researchers in various fields, especially in medical applications, due to properties such as controllable magnetic behavior. In this regard, magnetic nanoparticles have been used for treatment using magnetic hyperthermia.
Materials and Methods: In this study, spinel ferrite nanoparticles Co0.5Zn0.5Fe2O4 were synthesized by two methods: co-precipitation and hydrothermal, using materials such as iron chloride, cobalt chloride, zinc chloride, sodium hydroxide, and ethanol. Their structural, morphological, and magnetic properties were investigated.
Results: X-ray diffraction results confirmed the formation of a pure spinel phase in both samples. Field emission scanning electron microscopy images showed that the nanoparticles synthesized by the hydrothermal method had smaller sizes and a more uniform distribution compared to the samples prepared by the co-precipitation method. Fourier transform infrared spectroscopy confirmed the presence of characteristic spinel ferrite bands corresponding to octahedral and tetrahedral sites. Vibrating sample magnetometry results indicated that the sample synthesized by the hydrothermal method possessed a higher saturation magnetization. Consequently, the performance of this sample in magnetic hyperthermia was evaluated.
Conclusion: The results indicated that the nanoparticles synthesized by the hydrothermal method demonstrated a desirable ability to release heat, achieving a saturation magnetization of 60.543 emu/g and a specific absorption rate of 20.9 W/g, thus possessing suitable capacity for applications in nanomedicine and magnetic hyperthermia.
Keywords
Subjects

1. Baričić M, Maltoni P, Barucca G, Yaacoub N, Omelyanchik A, Canepa F, et al. Chemical engineering of cationic distribution in spinel ferrite nanoparticles: the effect on the magnetic properties. Phys Chem Chem Phys. 2024;26(7):6325–34. https://doi.org/10.1039/d3cp06029b
2. Salih SJ, Mahmood WM. Review on magnetic spinel ferrite (MFe₂O₄) nanoparticles: from synthesis to application. Heliyon 2023;9(6):e16601. https://doi.org/10.1016/j.heliyon.2023.e16601
3. Rahman MN, Hossain MA. Transition metal based spinel ferrites: a review. Mater Today Sustain. 2026;33:101252. https://doi.org/10.1016/j.mtsust.2025.101252
4. Vergis BR, Kottam N, Krishna RH, Kumar GA. Comparison of magnetic and dielectric properties of transition metal nanospinel ferrites, MFe₂O₄ (M = Co, Cu, Ni, Zn), synthesized by one-pot combustion route. Mater Today Proc. 2022;49:870–7. https://doi.org/10.1016/j.matpr.2021.06.177
5. Mameli V, Musinu A, Ardu A, Ennas G, Peddis D, Niznansky D, et al. Studying the effect of Zn-substitution on the magnetic and hyperthermic properties of cobalt ferrite nanoparticles. Nanoscale 2016;8(19):10124-37. https://doi.org/10.1039/c6nr01303a
6. Aftabi A, Babakhani A, Khoshlahni R. Optimized Zn substituted CoFe₂O₄ nanoparticles for high efficiency magnetic hyperthermia in biomedical applications. Sci Rep. 2025;15(1):10039. https://doi.org/10.1038/s41598-025-94535-8
7. Shaterabadi Z, Nabiyouni G, Asadi ZM, Iglesias GR, Soleymani M. Enhanced magnetic hyperthermia efficiency in poly vinyl alcohol-coated zinc-substituted cobalt ferrite nanoparticles: correlated effects of zinc content and applied magnetic field strength. Ceram Int. 2023;49(21):33934–43. https://doi.org/10.1016/j.ceramint.2023.08.088
8. Shahbahrami B, Rabiee SM, Shidpoor R. An overview of cobalt ferrite core-shell nanoparticles for magnetic hyperthermia applications. Adv Ceram Prog. 2020;6(1):1–15. https://www.acerp.ir/article_105923.html
9. Ahmad SI. A review on synthesis and magnetic hyperthermia application of spinel nano ferrite. J Umm Al-Qura Univ Appl Sci. 2025;12:658-702 https://doi.org/10.1007/s43994-025-00262-1
10. Somvanshi SB, Kharat PB, Khedkar MV, Jadhav K. Hydrophobic to hydrophilic surface transformation of nano-scale zinc ferrite via oleic acid coating: magnetic hyperthermia study towards biomedical applications. Ceram Int. 2020;46(6):7642–53. https://doi.org/10.1016/j.ceramint.2019.11.265
11. Aghaie F, Soltani-Nezhad S, Hasani S. Effect of calcination temperature on the properties of cobalt ferrite nanoparticles synthesized by the auto-combustion sol-gel method in the presence of albumin. J Adv Mater Eng. 2025;44(3):21–40. https://doi.org/10.47176/jame.44.3.1099
12. Soltani-Nezhad S, Hasani S, Mashreghi A. Synthesis and characterization of Ca²⁺ and Gd³⁺ doped cobalt ferrite nanoparticles coated with chitosan and polyethylene glycol. J Adv Mater Eng. 2023;42(1):1–16. https://doi.org/10.47176/jame.42.1.1014
13. Shayestefar M, Mashreghi A, Hasani S. The effect of Dy-doping on the structural and magnetic properties of Mn-Zn ferrite nanoparticles. J Adv Mater Eng. 2022;40(1):65–81. https://doi.org/10.47176/jame.40.1.10361
14. Ati AA, Abdalsalam AH, Hasan AS. Thermal, microstructural and magnetic properties of manganese substitution cobalt ferrite prepared via co-precipitation method. J Mater Sci Mater Electron. 2021;32(3):3019–37. https://doi.org/10.1007/s10854-020-05053-4
15. Stein C, Bezerra M, Holanda G, André-Filho J, Morais P. Structural and magnetic properties of cobalt ferrite nanoparticles synthesized by co-precipitation at increasing temperatures. AIP Adv. 2018;8(5):056303. https://doi.org/10.1063/1.5006321
16. Andersen HL, Granados-Miralles C, Saura-Múzquiz M, Stingaciu M, Larsen J, Søndergaard-Pedersen F, et al. Enhanced intrinsic saturation magnetization of ZnₓCo₁₋ₓFe₂O₄ nanocrystallites with metastable spinel inversion. Mater Chem Front. 2019;3(4):668–79. https://doi.org/10.1039/c9qm00012g
17. Ding Z, Wang W, Wu S, Liu JP. Synthesis and characterization of Co–Zn ferrite nanoparticles by hydrothermal method: a comparative study. IEEE Trans Magn. 2015;51(11):1–4. https://doi.org/10.1109/TMAG.2015.2437895
18. Talebniya S, Saeri M, Sharifi I, Doostmohammadi A. Characterization of chitosan and polyethylene glycol biopolymers coatings on magnetic spinel FeFe₂O₄ nanoparticles. J Adv Mater Eng. 2022;41(1):81–95. https://sid.ir/paper/1043476/en
19. Staruch M, Hires D, Violette D, Navarathne D, Sotzing G, Jain M. Structural and magnetic properties of CoFe₂O₄ and Co₀.₅Zn₀.₅Fe₂O₄ nanoparticles for the magnetoelectric composite films. Integr Ferroelectr. 2011;131(1):102–9. https://doi.org/10.1080/10584587.2011.621057
20. Jelvani A, Amiri GR, Fatahian S, Manouchehri S, Habibi M, Dehaghi RM. Magnetic properties comparison of Co₀.₅Zn₀.₅Fe₂O₄ nanoparticles prepared by different methods. Optoelectron Adv Mater Rapid Commun. 2011;5(11):1216–8.
21. Powar RR, Phadtare VD, Parale VG, Park H-H, Pathak S, Kamble PR, et al. Structural, morphological, and magnetic properties of ZnₓCo₁₋ₓFe₂O₄ (0 ≤ x ≤ 1) prepared using a chemical co-precipitation method. Ceram Int. 2018;44(17):20782–9. https://doi.org/10.1016/j.ceramint.2018.08.079
22. Lv Y, Yang Y, Fang J, Zhang H, Peng E, Liu X, et al. Size dependent magnetic hyperthermia of octahedral Fe₃O₄ nanoparticles. RSC Adv. 2015;5(94):76764–71. https://doi.org/10.1039/c5ra12558h
23. Khandhar AP, Ferguson RM, Simon JA, Krishnan KM. Tailored magnetic nanoparticles for optimizing magnetic fluid hyperthermia. J Biomed Mater Res A 2012;100(3):728–37. https://doi.org/10.1002/jbm.a.34011
24. Iacovita C, Florea A, Dudric R, Pall E, Moldovan AI, Tetean R, et al. Small versus large iron oxide magnetic nanoparticles: hyperthermia and cell uptake properties. Molecules 2016;21(10):1357. https://doi.org/10.3390/molecules21101357
25. Jalili H, Aslibeiki B, Varzaneh AG, Chernenko VA. The effect of magneto-crystalline anisotropy on the properties of hard and soft magnetic ferrite nanoparticles. Beilstein J Nanotechnol. 2019;10:1348–59. https://doi.org/10.3762/bjnano.10.133
26. Hasan AM, Ismail MM, Hussain WA. Tailoring Zn-Co ferrite nanoparticles for enhanced dye removal: structural, magnetic, and adsorption properties. J Umm Al-Qura Univ Appl Sci. 2025. https://doi.org/10.1007/s43994-025-00251-4
27. Hutamaningtyas E, Utari, Suharyana, Wijayanta A, Purnama B. FTIR and structural properties of co-precipitated cobalt ferrite nano particles. J Phys Conf Ser. 2016;776:012023. https://doi.org/10.1088/1742-6596/776/1/012023
28. Fayazzadeh S, Khodaei M, Arani M, Mahdavi S, Nizamov T, Majouga A. Magnetic properties and magnetic hyperthermia of cobalt ferrite nanoparticles synthesized by hydrothermal method. J Supercond Nov Magn. 2020;33(7):2227–33. https://doi.org/10.1007/s10948-020-05490-6
29. Wirthl B, Decuzzi P, Schrefler BA, Wall WA. Computational modelling of cancer nanomedicine: integrating hyperthermia treatment into a multiphase porous-media tumour model. Int J Numer Method Biomed Eng. 2025;41(8):e70074. https://doi.org/10.1002/cnm.70074
30. El-Boubbou K, Lemine O, Algessair S, Madkhali N, Al-Najar B, AlMatri E, et al. Preparation and characterization of various PVPylated divalent metal-doped ferrite nanoparticles for magnetic hyperthermia. RSC Adv. 2024;14(22):15664–79. https://doi.org/10.1039/d4ra01600a
31. Yu X, Chen X, Yang F, Li C, Yuan L, Zhu X, et al. Effect of Zn²⁺ substitution on heating efficiency of Zn-Co-Cr ferrite nanoparticles for self-regulating temperature hyperthermia. Ceram Int. 2025;51(29 Pt A):60471–80. https://doi.org/10.1016/j.ceramint.2025.10.245
 
 

تحت نظارت وف بومی