A
-
A. A. Golafshani,
Seismic Vulnerability of Special Structures: A Case Study of Toos Power Plant Stack [Volume 25, Issue 2, 2007, Pages 73-91]
-
A. Bakhshi,
Seismic Vulnerability of Special Structures: A Case Study of Toos Power Plant Stack [Volume 25, Issue 2, 2007, Pages 73-91]
-
A. F. Nateghi,
Development of Fragility and Reliability Curves and Seismic Vulnerability Evaluation of Talehzang Concrete Bridge [Volume 25, Issue 1, 2006, Pages 79-99]
-
A. Najafi Zadeh,
Drawing CCCT Diagrams and Investigation of Deformation Effects on Martensite and Bainite Trabsformations in NiCrMoV Steel [Volume 25, Issue 1, 2006, Pages 149-165]
-
A. R. Safari,
Theoretical and Experimental Collapse Analysis of Ring Stiffened Shells Using Finite Element Software Packages and Application of Results to a Submarine Pressure Hull [Volume 25, Issue 1, 2006, Pages 227-236]
-
A. Saidi,
Study of Anatase-to-Rutile Phase Transformation in Milled and Unmilled Samples [Volume 25, Issue 1, 2006, Pages 207-216]
-
A. Shafyei and N. J. Welham,
Study of Anatase-to-Rutile Phase Transformation in Milled and Unmilled Samples [Volume 25, Issue 1, 2006, Pages 207-216]
-
A. Vasseghi,
Development of Fragility and Reliability Curves and Seismic Vulnerability Evaluation of Talehzang Concrete Bridge [Volume 25, Issue 1, 2006, Pages 79-99]
-
A. Zaery,
Increase of Sliding Mode Controller Stability Limit [Volume 25, Issue 2, 2007, Pages 205-212]
B
-
B. Daei,
Gradient-based Ant Colony Optimization for Continuous Spaces [Volume 25, Issue 1, 2006, Pages 33-45]
D
-
D. Mostofinejad and M. Hoseinian,
An Investigation of Coarse Aggregate, Water-Cement Ratio, and Silika Fume on Frost Resistance of HS Concrete [Volume 25, Issue 2, 2007, Pages 31-49]
E
-
Ebrahim Hajidavalloo,
Evaluation of Evaporative Cooling for Heat Transfer in the Condenser of Window-Air Conditioners [Volume 25, Issue 1, 2006, Pages 135-147]
-
E. Shasavandi,
A Rapid Optimization Method for Slip Surface in Earth Slopes Using Genetic Algorithm [Volume 25, Issue 2, 2007, Pages 93-112]
-
E. Shirani,
Mixed Large-Eddy Simulation Model for Turbulent Flows across Tube Bundles Using Parallel Coupled Multiblock NS Solver [Volume 25, Issue 2, 2007, Pages 131-149]
F
-
F. Farhat-Nia and M. Salimi,
Analysis of Rolling Process for Clad Sheet Using the Modified Slab Method [Volume 25, Issue 1, 2006, Pages 121-134]
-
F. Nateghi,
Analytical Assessment of the Behaviour of the Masonry Wall Strengthed by Steel Mesh and Shotcrete [Volume 25, Issue 2, 2007, Pages 213-221]
-
F. Nateghi-Elahi,
Study of Energy Dissipation in Accordion Thin-Walled Tubes under Axial Cyclic Loads [Volume 25, Issue 1, 2006, Pages 101-119]
G
-
GH. Moslehi and H. Ghahar,
A Heuristic Algorithm for Project Scheduling Problem to Maximizing the Net Present Value [Volume 25, Issue 2, 2007, Pages 11-30]
-
G. Mirjalily,
Optimum Local Decision Rules in a Distributed Detection System with Dependent Observations [Volume 25, Issue 2, 2007, Pages 1-10]
H
-
Hassan Haddadpour,
Stress Analysis of Flight Vehicles under Flight Conditions [Volume 25, Issue 1, 2006, Pages 217-226]
-
H. Hossieni,
Optimum Local Decision Rules in a Distributed Detection System with Dependent Observations [Volume 25, Issue 2, 2007, Pages 1-10]
-
H. Moeshginkelk,
Neural-Network-Aided On-line Diagnosis of Broken Bars inInduction Motors [Volume 25, Issue 1, 2006, Pages 47-61]
M
-
M. Danesh,
Neural-Network-Aided On-line Diagnosis of Broken Bars inInduction Motors [Volume 25, Issue 1, 2006, Pages 47-61]
-
M. Darbandi,
Developing a Shock-Capturing Formulation with Higher Performance to Capture Normal Standing Shock in All-Speed Regime [Volume 25, Issue 2, 2007, Pages 167-181]
-
M. Ebrahimi,
Neural-Network-Aided On-line Diagnosis of Broken Bars inInduction Motors [Volume 25, Issue 1, 2006, Pages 47-61]
-
M. Eftekhari,
Gradient-based Ant Colony Optimization for Continuous Spaces [Volume 25, Issue 1, 2006, Pages 33-45]
-
M. E. Hamedani Golshan,
Application of Tabu Search to Optimal Placement of Distributed Generation and Reactive Power Sources [Volume 25, Issue 1, 2006, Pages 17-31]
-
M. Ghayour,
Theoretical and Experimental Collapse Analysis of Ring Stiffened Shells Using Finite Element Software Packages and Application of Results to a Submarine Pressure Hull [Volume 25, Issue 1, 2006, Pages 227-236]
-
M. H. Bagheripour,
A Rapid Optimization Method for Slip Surface in Earth Slopes Using Genetic Algorithm [Volume 25, Issue 2, 2007, Pages 93-112]
-
M. H. Enayati and M. Salehi,
An Investigation of the Use of Ni3Al Intermetallic Compound for Fabrication of Al Matrix Composites [Volume 25, Issue 2, 2007, Pages 183-190]
-
M. Jafarboland,
Robust Tracking Control of Satellite Attitude Using New EKF for Large Rotational Maneuvers [Volume 25, Issue 1, 2006, Pages 1-15]
-
M. Khan-Mohammadi and M. S. Marefat,
Experimental Evaluation of Performance Criteria for Reinforced Concrete Beams under Cyclic Loading [Volume 25, Issue 1, 2006, Pages 63-77]
-
M. Mashayekhi,
Ductile Damage Evolution under Triaxial Stress Conditions: Computational and Experimental Evaluations [Volume 25, Issue 2, 2007, Pages 151-165]
-
M. Moradiyan,
Neural-Network-Aided On-line Diagnosis of Broken Bars inInduction Motors [Volume 25, Issue 1, 2006, Pages 47-61]
-
M. Motamedi,
Study of Energy Dissipation in Accordion Thin-Walled Tubes under Axial Cyclic Loads [Volume 25, Issue 1, 2006, Pages 101-119]
-
M. R. Rahimi pour and M. Moayeri,
Investigation of Defects in Ferro-Tic Composites and their Prevention [Volume 25, Issue 1, 2006, Pages 167-178]
-
M. R. Tabeshpour,
Seismic Vulnerability of Special Structures: A Case Study of Toos Power Plant Stack [Volume 25, Issue 2, 2007, Pages 73-91]
-
M. R. Toroghinejad,
Investigation of Parameters Involved in the Production of Aluminum Matrix Composites Using Hot Powder Extrusion [Volume 25, Issue 1, 2006, Pages 179-188]
-
M. Sayadi and M. M. Moshksar,
Investigation of Parameters Involved in the Production of Aluminum Matrix Composites Using Hot Powder Extrusion [Volume 25, Issue 1, 2006, Pages 179-188]
-
M. Shamanian,
Drawing CCCT Diagrams and Investigation of Deformation Effects on Martensite and Bainite Trabsformations in NiCrMoV Steel [Volume 25, Issue 1, 2006, Pages 149-165]
-
M. Sheikhi and H. Haji-Kazemi,
A Theoretical Study of the Behavior of Reinforced Concrete Columns Strengthened by Steel Plates and Transverse Reinforcements [Volume 25, Issue 2, 2007, Pages 65-72]
-
M. Talebi,
Mixed Large-Eddy Simulation Model for Turbulent Flows across Tube Bundles Using Parallel Coupled Multiblock NS Solver [Volume 25, Issue 2, 2007, Pages 131-149]
-
M. Ziaeefar,
Study of Energy Dissipation in Accordion Thin-Walled Tubes under Axial Cyclic Loads [Volume 25, Issue 1, 2006, Pages 101-119]
N
-
N. Sadati,
Robust Tracking Control of Satellite Attitude Using New EKF for Large Rotational Maneuvers [Volume 25, Issue 1, 2006, Pages 1-15]
-
N. Setoudeh,
Study of Anatase-to-Rutile Phase Transformation in Milled and Unmilled Samples [Volume 25, Issue 1, 2006, Pages 207-216]
R
-
R. Bagheri and M.A. Golozar,
Mechanical Properties of Polypropylene Coating Containing Maleic Anhydride on Plain Carbon Steel [Volume 25, Issue 2, 2007, Pages 191-203]
-
R. Shateri,
Drawing CCCT Diagrams and Investigation of Deformation Effects on Martensite and Bainite Trabsformations in NiCrMoV Steel [Volume 25, Issue 1, 2006, Pages 149-165]
-
R. Taherian,
Drawing CCCT Diagrams and Investigation of Deformation Effects on Martensite and Bainite Trabsformations in NiCrMoV Steel [Volume 25, Issue 1, 2006, Pages 149-165]
S
-
S. A. Arefifar,
Application of Tabu Search to Optimal Placement of Distributed Generation and Reactive Power Sources [Volume 25, Issue 1, 2006, Pages 17-31]
-
S. M. Miresmaeili and S. Shabestari,
Study of the Mechanism and Causes of Pore Formation in Sr-modified Al-Si Alloys [Volume 25, Issue 1, 2006, Pages 189-206]
-
S. Mortazavi,
A Numerical Study of Drop Motion in Poiseuille Flow [Volume 25, Issue 2, 2007, Pages 113-129]
-
S. M. Zahrai and B. Rad,
Analytical Investigation of TADAS Damper Applied in Seismic Rehabilitation & Design of Concrete Structures [Volume 25, Issue 2, 2007, Pages 51-64]
-
S. Ziaei-Rad,
Ductile Damage Evolution under Triaxial Stress Conditions: Computational and Experimental Evaluations [Volume 25, Issue 2, 2007, Pages 151-165]
V
-
V. Mokarizadeh,
Developing a Shock-Capturing Formulation with Higher Performance to Capture Normal Standing Shock in All-Speed Regime [Volume 25, Issue 2, 2007, Pages 167-181]
Your query does not match with any item