Synthesis of Three-dimensional Graphene and Optimization of Its Morphology

Authors

Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran.

Abstract

Due to electrical properties (high electron mobility) and electrochemical characteristics (high electron transport rate), graphene-based  materials have been widely applied for various scientific fields. However, due to their two-dimensional  structures, these materials have low active sites for reaction. Therefore, changing from two-dimensional sheets dimensional to the three-dimensional ones  could provide graphene-based materials with high specific surface and electron and mass transport particles. For these purpose, reduced graphene oxide (rGO) and polystyren (PS) aqueous solution were mixed with two different  weight ratios kinetic. In this study, the three-dimensional graphene (3DG) was synthesized with graphene oxide using sacrificial PS particles. For this purpose, rGO and the PS aqueous solution were mixed with two different weight ratios of 95:5 and 85:15. Then, the 3DG-PS scaffolds were synthesized by controlling the pH value in the range of 6-8. Subsequently, PS particles were removed by immersing the synthesized scaffolds in toluene. In this research, the effect of filtering through the member filter and centrifuge on the morphology of the  scaffolds was  investigated. The scaffolds were characterized with X-ray diffraction and scanning electron microscopy. The results showed the formation of 3DG with a uniform distribution of porosities by  using the  centrifuge procedure. Moreover, the sacrificial PS particles were completely removed when the rGO to PS weight ratio was 95:5. So, 3DG with the uniform distribution of microscopy porosity could be synthesized through the sacrificial mold method and the centrifuge procedure; graphene oxide was also reduced with the PS weight ratio of 95:5. Further, based on the electrochemical evaluation of  this optimized sample, as compared to the  rGO , it was found that the 3DG had better electrochemical properties than the rGO. Therefore, 3DG with  the optimized rGO to PS weight ratio of 95:5 could be an ideal substitute for rGO in electrochemical applications

Keywords

References

1. Chen, W., Yan, L., and Bangal, P. R., “Preparation of Graphene by the Rapid and Mild Thermal Reduction of Graphene Oxide Induced by Microwaves”, Carbon, Vol. 48, pp. 1146-1152, 2010.
2. Yan, Q., Liu, Q., and Wang, J., “A Simple and Fast Microwave Assisted Approach for the Reduction of Graphene Oxide”, Ceramics International, Vol. 42, pp. 3007-3013, 2016.
3. Álvarez‐Romero, G., Alarcon‐Angeles, G., and Merkoçi, A., “Graphene: Insights of Its Application in Electrochemical Biosensors for Environmental Monitoring”, Biosensors Nanotechnology, pp. 111-140, 2014.
4. Shao, Y., Wang, J., Engelhard, M., Wang, C., and Lin, Y., “Facile and Controllable Electrochemical Reduction of Graphene Oxide and Its Applications”, Journal of Materials Chemistry, Vol. 20, pp. 743-748, 2010.
5. Ma, Y., Zhao, M., Cai, B., Wang, W., Ye, Z., and Huang, J., “3D Graphene Foams Decorated by CuO Nanoflowers for Ultrasensitive Ascorbic Acid Detection”, Biosensors and Bioelectronics, Vol. 59, pp. 384-388, 2014.
6. Li, C., and Shi, G., “Three-dimensional Graphene Architectures”, Nanoscale, Vol. 4, pp. 5549-5563, 2012.
7. Bai, H., Li, C., Wang, X., and Shi, G., “A pH-sensitive Graphene Oxide Composite Hydrogel”, Chemical Communications, Vol. 46, pp. 2376-2378, 2010.
8. Xu, Y., Sheng, K., Li, C., and Shi, G., “Self-assembled Graphene Hydrogel Via a One-step Hydrothermal Process”, ACS Nano, Vol. 4, pp. 4324-4330, 2010.
9. Niu, Z., Chen, J., Hng, H. H., Ma, J., and Chen, X., “A Leavening Strategy to Prepare Reduced Graphene Oxide Foams”, Advanced Materials, Vol. 24, pp. 4144-4150, 2012.
10. Lee, K. G., Jeong, J. -M., Lee, S. J., Yeom, B., Lee, M. K., and Choi, B. G., “Sonochemical-assisted Synthesis of 3D Graphene/nanoparticle Foams and Their Application in Supercapacitor”, Ultrasonics Sonochemistry, Vol. 22, pp. 422-428, 2015.
11. Choi, B. G., Chang, S. -J., Lee, Y. B., Bae, J. S., Kim, H. J., and Huh, Y. S., “3D Heterostructured Architectures of Co3O4 Nanoparticles Deposited on Porous Graphene Surfaces for High Performance of Lithium ion Batteries”, Nanoscale, Vol. 4, pp. 5924-5930, 2012.
12. Choi, B. G., Yang, M., Hong, W. H., Choi, J. W., and Huh, Y. S., “3D Macroporous Graphene Frameworks for Supercapacitors with High Energy and Power Densities”, ACS Nano, Vol. 6, pp. 4020-4028, 2012.
13. Wu, Y., Huang, M., Song, N., and Hu, W., “Electrochemical Detection of Guaiacol in Bamboo Juice Based on the Enhancement Effect of RGO Nanosheets”, Analytical Methods, Vol. 6, pp. 2729-2735, 2014.
Journal of Advanced Materials in Engineering (Esteghlal)
Volume 37, Issue 2
September 2018
Pages 1-12

Files

Share

How to cite

Statistics

ارتقاء امنیت وب با وف ایرانی